Sponsor Highlight: Spirol
Manchester Stinger Motorsports
Some of the most important parts on the MAN26 are ones you’d never spot from the paddock. For another season, SPIROL is backing Manchester Stinger Motorsports with heat-set inserts and compression limiters, small metal parts that let our plastic and 3D-printed components be bolted together properly.

Holding the intake together
Our intake is one of the most complex parts on the car. The restrictor, plenum and runners are SLS-printed, which lets us design internal flow shapes that could never be machined. The catch is that printed plastic doesn’t hold a bolt well. Tighten it down and the plastic slowly crushes and relaxes until the joint goes loose.
That’s a problem, because the intake has to be completely airtight. Formula Student rules force all of the engine’s air through a single restrictor, and at technical inspection the inlet is blocked to prove it: if the engine doesn’t stall, the car doesn’t pass. A part coming loose on track can also get the run disqualified.
SPIROL’s compression limiters solve this. They’re metal sleeves that sit inside each bolt hole, so the bolt clamps against metal rather than squashing the plastic. The joint stays tight through heat, vibration and a full endurance run.
Threads that last
Heat-set inserts do a similar job for threads. Instead of a bolt cutting into plastic, which wears out a little every time it’s undone, a brass insert is heated and pressed into the part, giving it a proper metal thread. We use them across the car’s electronics enclosures, which get opened [constantly] during testing and on event weekends. The inserts mean every lid can come off and go back on without stripping a thread, and the seals keeping water out of the electronics stay clamped tight.
Thank you, SPIROL
To everyone at SPIROL: thank you for backing us for another year and helping us build a car that holds together. We can’t wait to show you what the MAN27 can do on track next summer.
← ALL NEWS
